Foro Computacion Salta, Tucuman y Jujuy

Marca: Cisco Linksys
Modelo: SPA-3000
Especificaciones Tecnicas
SPA-3000 Telephony Features:
Linksys - Sipura SPA-3000 Analog Adapter
Ports: 1 FXS + 1 FXO + 1 Ethernet
Supported Protocols: SIP
               
VoIP to PSTN (USA) Service Call Origination and Termination
PSTN (USA) to VoIP Service Call Origination and Termination
Single or Dual Stage Dialing
Service Authentication via PIN, Digest, Caller ID (Bellcore Type 1)
Per Call Authentication and Associated Routing
Least Cost Routing Support
Terminating Impedance Agnostic - 8 Configurable Settings
Call Waiting, Cancel Call Waiting
Caller ID Detection (Bellcore Type 1)
Caller ID with Name/Number (Multinational Varients) Display
Caller ID Blocking
Call Waiting Caller ID with Name/Number
Call Forwarding to PSTN or VoIP Service: No Answer/Busy/All
Do Not Disturb
Call Transfer
Three-Way Conference Calling with Local Mixing
Message Waiting Indication - Visual and Tone Based
Call Return and Call Back on Busy
Call Blocking with Toll Restriction
Distinctive Ringing
Off-Hook Warning Tone
Selective/Anonymous Call Rejection
Hot Line and Warm Line Calling
Speed Dialing of 8 Numbers/Addresses
Music on Hold
Forward Calls to VoIP service - Selective, Authenticated, All
Forward Calls to PSTN service - Selective, Authenticated, All
PSTN Line Sharing with Multiple Extensions
Automatic PSTN Fallback (Loss of Power or IP Service to Unit - with Quiescence to Normal Operations)
Advanced Inbound and Outbound Call Routing
Single Stage and Two Stage Dialing
Independent Configurable Dial Plans - Up to 8
Force PSTN Disconnection
Sequential Dialing Support                 

VoIP to PSTN Authentication and Routing:
                VoIP to PSTN Gateway Enable/Disable
                VoIP Caller Auth Method (None, PIN, HTTP Digest)
                VoIP PIN Max Retry Setting
                One Stage Dialing Enable/Disable
                VoIP Caller ID Pattern Matching
                VoIP Access Allowed Caller List (No Further Authentication)
                VoIP Caller PIN and Associated Dial Plan
PSTN to VoIP Authentication and Features:
              PSTN to VoIP Gateway Enable/Disable
              Caller Auth Method: None, PIN, Caller ID
              Ring Through to FXS Enable/Disable
              Ring Through Tone - Configurable
              Caller ID (Bellcore 1) for VoIP Service Access
              Caller ID Enable/Disable
              PIN Max Retry Settings
              Access Allowed Caller List (No Further Authentication)
              Caller PIN and Associated Dial Plan
              Least Cost Routing (via Outbound VoIP - Line1 Dial Plan)
               
FXO Behavior:             
               VoIP Answer Delay Timer
               PSTN Answer Delay Timer
               VoIP PIN Digit Time-Out Timer
               PSTN PIN Digit Time-Out Timer
               PSTN-to-VoIP Call Max Dur Timer
               VoIP-to PSTN Call Max Dur Timer
               PSTN Ring Through Delay Timer
               PSTN Dialing Delay Timer
               VoIP DIG Refresh Interval Timer
               PSTN Ring Time-out Timer

PSTN Disconnection Detection:
                CPC (Removal of Tip/Ring Voltage Momentarily)
                Polarity Reversal
                Long Silence (Confugrable Time Setting)
                Disconnect Tone (e.g. Reorder Tone)
                FXO Port Impedance - Configurable to 16 settings
                Ring Frequency - Configurable
                SPA to PSTN and PSTN to SPA Gain Settings
                Ring Frequency - Maximum Setting
                Ring Validation Time Setting
                Tip/Ring Voltage Adjustment Setting
                Ring Indication Delay Setting
                Operational Loop Current Minimum Value
                Ring Time-out Setting
                On-Hook Speed Setting
                Ringer Impedance Setting
                Line-in-Use Voltage Setting                 

Regulatory Compliance:
                FCC (Part 15 Class B and Part 68) , CE , ICES-003
               
Security:
                Password Protected System Reset to Factory Default
                Password Protected Admin and User Access Authority
                Provisioning/Configuration/Authentication:
                HTTP Digest - Encrypted Authentication via MD5 (RFC 1321)
                Up to 256-bit AES Encryption